Add to cart
  • Description
  • More

Power distribution system optimized for 6V servos.

12 receiver channels in and 24 servo channels out.

Optimized for use with 2S LiFe (A123) batteries.

Also suitable for LiPo with an additional BEC.

Specification:

  • Link to the User Manual
  • 12 Inputs (A,B,C,D,E,F,G,H,I,J,K,L)
  • 24 Buffered/Filtered and amplified outputs (A,A,B,B,B,B,C,C,C,C,D,D,E,E,F,F,G,G,G,H,I,J,K,L)
  • Both power and servo signal are amplified -
  • The output can drive up to 10 meters servo wire per channel
  • Optimized for use with 2 cell LiFe (A123) battery. Can be used without a BEC.
  • Can be used with 4/5 cell NiCd or NiMh battery
  • Optimized for 6V servos
  • No seperate Radio battery needed
  • 5 Volt 1.5 Amp Regulated output for receiver on all channels for improved redundancy
  • "Flight Deck" for mounting receiver at top of board. Can be removed (permanent) if desired
  • Dual Battery Inputs - Auto Load sharing and
  • Failsafe switch over between batteries 
  • "Power Match" LEDs show which battery is battery is being used, or when both are equal
  • Includes rubber grommets and aluminum standoffs and screws
  • 72 Amp power bus (36 Amp per input)
  • Deans Input Connections
  • Includes 6 leads for connection to receiver, additional leads can be purchased seperately
  • Works with PPM , PCM, 2.4Ghz systems
  • 5.4 Volt minimum input is required (pref regulated) - 7.2 Volt Max Input
  • Link to the generic BlueBox manual: User Manual  Be carefull it's not a specific BB-LV manual. 

The pictures below show some sample configurations of the 8-16LV BlueBox:

 

 

Related Products